Voice: Help - HWIC-4ESW + ILPM + PWR unit but phone not lighting up

rchase

BR1#show inv
NAME: "2821 chassis", DESCR: "2821 chassis"
PID: CISCO2821 , VID: V06 , SN: FTX1408AJ2Z

NAME: "WAN Interface Card - Serial (1T) on Slot 0 SubSlot 0", DESCR: "WAN Interface Card - Serial (1T)"
PID: WIC-1T= , VID: 1.0, SN: 2296xxxx

NAME: "One port T1 voice interface daughtercard on Slot 0 SubSlot 1", DESCR: "One port T1 voice interface daughtercard"
PID: VWIC-1MFT-T1 , VID: V02, SN: 3664xxxx

NAME: "4 Port FE Switch on Slot 0 SubSlot 2", DESCR: "4 Port FE Switch"
PID: HWIC-4ESW , VID: V01 , SN: FOC14153xxx

NAME: "WIC/VIC/HWIC 2 Power Daughter Card", DESCR: "4-Port HWIC-ESW Power Daughter Card"
PID: 800-IL-PM-2 , VID: V01 , SN: FOC14416xxx

NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 4", DESCR: "PVDMII DSP SIMM with four DSPs"
PID: PVDM2-64 , VID: V01 , SN: FOC104xxxxx



So I originally purchased the HWIC-4ESW, then learned I need a PWR unit and ILPM. bought both of those, plugged the ILPM daughter card into the HWIC, swapped the old PWR unit, connected the new one to the motherboard, but still phone doesnt light up. Any ideas?

pitviper

The new PSU came with the 2nd cable correct? I remember a lot of them were missing the cable when I was looking.

rchase

So it turns out, after I read this article,:

Cisco 2800 Series Hardware Installation - Installing and Upgrading Internal Modules in Cisco 2800 Series Routers* [Cisco 2800 Series Integrated Services Routers] - Cisco Systems

that I need to jump the power from the PSU to the motherboard with a little (RED/WHITE) jumper cable which was NOT included with either my HWIC, ILPM, or PWR unit purchases. NOTE: this jumper is separate from the main, larger, multi color jumper that powers the rest of the 2821, also the black/white/red jumper powers the fans. Luckily I found the cable inside one of my other 2821s, so I hooked it up and now the phones light up. Pic attached of the jumper (pointing at with a screwdriver)

Never knew getting PoE on my HWIC would be so involved lol

pitviper

Yeah, the cable comes with the PSU new - no clue why most sellers don't include it.

rchase

Most sellers dont know what theyre selling haha. I was stoked to pickup about 128 channels of PVDMs that werent listed in my 2821 purchases

rchase

So I took another look at it, and I'm actually not sure if that RED/wHITE jumper was needed. But theres a larger PSU to motherboard cable that I missed that IS needed: Pic attached



(Black cable, wraps around the right side and then under the multi color main power connection)