Configuring OSPF on Ethernet int v. Serial int

yazmnh87yazmnh87 Member Posts: 8 ■□□□□□□□□□
in CCNA & CCENT
Is there a major difference between configuring OSPF on Ethernet interfaces v. Serial interfaces? I've been trying to work through some OSPF labs and I can't seem to send packets from the serial ports to the Ethernet ports all configured with OSPF. I know mostly WAN protocols are configured on serial ports, but I would think it would matter too much. If anyone has any thoughts or general input on OSPF I'd appreciate it, thanks!
· Share on FacebookShare on Twitter

Comments

  • Adam BAdam B Member Posts: 108 ■■□□□□□□□□
    Probably made an error that you overlooked, like accidentally forgetting a route to add to the routing table or something like that. Just doublecheck your configurations make sure you have all the networks that you need to the table added
    2015 Goals: CCNP SWITCH [] SEC+ [ ] CCNP ROUTE [ ] CCNP TSHOOT [ ]

    · Share on FacebookShare on Twitter
  • fov001fov001 Member Posts: 35 ■■□□□□□□□□
    If you could show us your topology or configuration that would help us help you better
    · Share on FacebookShare on Twitter
  • StaunchyStaunchy Member Posts: 180
    Have you looked in the routing table if there is a connected route for that subnet? Also check that the interface line and protocol status is up.
    2016 Goals: CCNP R&S, CCNA Security, CCNP Security
    LinkedIn
    · Share on FacebookShare on Twitter
Sign In or Register to comment.