Book now with code EOY2025
Finally got this off my to-do list. Woot! I somehow let my JNCIE-ER lapse into an inactive state a number of months back (whoops), but it's now active again upgraded to ENT! It was a bit trickier than I expected, but mostly because there was more focus on subjects I wasn't expecting to be so heavy. If I took more time to…
Hello Everybody!!:D I passed the JNCIS-ENT today & I should say the exam was pretty easy . All you need to ace it is the two wonderful study guides on the Fastrack Juniper portal! You also get a 50% discount on it so its a pretty good deal! I did take some time to study for the exam but I should say its just similar in…
[FONT="]Hello,[/FONT] [FONT="] [/FONT] [FONT="]I need some help here, my JNCIE-SEC is going to expire next month. I need to prepare for JNCIP-SEC exam , but the course content has change slightly with the new topic ,Can someone help me to get PDF document for new JCNIP-SEC (JN0-634) . [/FONT]Appreciate your…
I have recently passed the JNCIA-Junos exam and would like to move on to the JNCIS-ENT exam. How do I go about studying for this? There seems to be limited resources available (books etc). Can anybody recommend any study guides / books / videos to help me prepare for this. I have access to Juniper kit and olive, so can get…
I need ebook / study material for JNCIP-ENT. Can anyone help me out ??
Hi Everyone, Been banging my head against this. The Googs isnt helping. Is it possible to to connect a Juniper (J2300) to a Cisco 2600 back to back via serial? I have both DCE-DTE and DCE-DCE cables. Neither result in Physical Link UP. Please advise!
Hello all: Question 1 of 2: Interpreting Filter CLI term TERM1 { from { prefix-list { PREFIX1; } protocol TCP; port [ 80 ]; } then accept; } Does that rule mean A, B, C, or D? A: source-address:PREFIX1, destination:ANY, protocol: TCP, source-or-destination-port:80 B: source-address:PREFIX1, destination:ANY, protocol: TCP,…
Hi Everybody, I have a J2300. The FPC always drops to offline when I boot up or restart the fpc. But this only happens when booting from the Compact Flash. I made a snapshot onto a USB and that boots up and runs good. So.. Compact Flash bad, USB good? Any advise? Thanks!
Hi Everyone, I picked up a Juniper J2300 off ebay. Its old but i thought it would be useful to lab with. My problem is that the USB port does not appear to see a USB device when plugged in. Here is some output below. Any ideas? root@J2300% dmesg | tail ... stuff removed... umass0: Generic Mass Storage, rev 2.00/1.01, addr…
Hi Everybody, I've been Googling and trying for days. Is it even possible to run Juniper Olive on ESXi? Any advise will be appreciated. Thanks!
It looks like you're new here. Sign in or register to get started.
Use code EOY2025 to receive $250 off your 2025 certification boot camp!