Book now with code EOY2025
Hi, Have anyone here attended the the cisco training course "Implementing and Configuring Cisco Identity Services Engine" and wrote the exam 500-254? I have been working a bit on Aruba ClearPass but never touched ISE so I'm excited to see how ISE compares to ClearPass.
I was watching a video that mentioned that core routers are used for transition purpose. In a service provider the purpose is to route traffic unlike an application provider in which it is a destination. In that case why can someone ping the core routers even though they only label switch packets?
I am about to dive head first into ROUTE, and wanted the advice of those who have been through it. I have frame switch sitting logically in the middle of routers simulating an NBMA network, as can be viewed on the attachment. I have not barely began to crack into the depths of routing protocols, just getting the lab fine…
Can anyone provide an example real world scenario where OSPF NSSA would be or has been used? My understanding of the theory is that a NSSA can contain an ASBR (unlike Stub areas), and this ASBR can redistribute external routes as Type 7 LSAs (basically type 5 LSAs in disguise). So a NSSA allows us to connect an ASBR to…
I am currently studying for my switch exam using Chris Bryant's video + book. What other materials have you guys used to passed and what do you feel like was most effective?
What are some good virtual labs that you experienced Cisco guys can recommend? How close are these labs to the real thing (that. using actual Cisco equipment). thanks in advance for your input.
Does any vrf have a seperate FIB or they all have same FIB?
Can I customer order both L2 and L3VPN at the same time? In that case, are the two CEs sites placed in the same subnet or different?
Please help, From R1, i can ping the loopback IP(3.3.3.3) that was advertised via BGP. But from R3 cant ping the loopback IP's of the R1 that was advertise via BGP. R1 ----EBGP---- R2IBGPR3 Kinly see below config: R1 interface Loopback0 ip address 2.2.2.2 255.255.255.255 ! interface Loopback1 ip address 192.168.1.1…
When I put some commands in GNS3 it says that the command is not recognized. What's the problem? How Can I fix it? (config-if)#power inline ... not recognized (config)# sdm prefer ... not recognized
It looks like you're new here. Sign in or register to get started.
Use code EOY2025 to receive $250 off your 2025 certification boot camp!